Cost-Effective Solution for Laser Cutting (Sword Mountain Protector)
The quality requirements for laser cutting are becoming increasingly stringent, and there are more and more cutting processing factories striving for both quality and manufacturing efficiency.
At the bottom of the cutting machine, the use of Sword Mountain (blade guide) is indispensable during cutting, providing support. However, Sword Mountain has a significant impact on quality. Issues such as iron chip accumulation, unevenness, tolerances, etc., need to be addressed. Therefore, many manufacturers increase the frequency of replacing Sword Mountain to maintain good quality. However, the cost of Sword Mountain consumption is often overlooked. But the German original manufacturer, Bio-Circle, has noticed it.
German Bio-Circle introduces the "Sword Mountain Protector," a cost-effective solution to reduce laser cutting costs.
Advantages include:
- Reducing iron chip accumulation on Sword Mountain
- Increasing the productivity of laser cutting
- Lowering labor costs
- Increasing machine utilization time
Iron chip splashing on metal surfaces
Actual customer tests (1 month) photos
Test location: Laser cutting factory in Taichung
Working hours: 8-12 hours/day
Operating procedure: After cutting Sword Mountain by oneself or purchasing new ones, first use FT 100/FT 300 to clean the surface oil or dust on Sword Mountain. After cleaning, use the Sword Mountain Protector to evenly brush or spray on the side and top of Sword Mountain with the original solution or diluted with water (the dilution ratio should not be too high). Wait for drying before conducting a one-month test.
▲ Without Sword Mountain protection (after one month of use)
▲ Using BIO-CIRCLE Sword Mountain Protector (after one month of use)
